Set stdma flag, Set stdma flag -47, Figure 3-49 hub bc demodulator properties menu – Comtech EF Data VMS v3.12.x Vipersat User Manual
Page 147: Command
Chapter
3 -
VMS Configuration
3-47
MN/22156, rev 12
Network Manager Configuration
Set STDMA Flag
It is important for the operator to set the STDMA flag on the network burst
controller(s). The VMS sets the flags for the other network devices automati-
cally.
1.
Right-click on the BC demodulator and select Properties from the drop-
down menu (figure 3-49).
Figure 3-49 Hub BC Demodulator Properties menu command
2. The dialog appearance with the correct setting is shown in the figures below.
• For a CDM-570/570L Burst Controller, select the Modem dialog, then
select the STDMA radio button, figure 3-50.
• For an SLM-5650A Burst Controller, select the Burst Controller check
box, figure 3-51.
Note for SLM-5650A Hub BC redundacy configurations: Do NOT select
the Burst Controller check box on redundant units. This flag is
unnecessary and may cause network communication problems. Should a
failover occur, the redundant unit will be automatically configured
exactly as the online unit, and this flag will be set correctly at that time.