Comtech EF Data VMS v3.12.x Vipersat - Manual (Page 299)

Chapter 5 - Configuring ROSS Units 5-11
MN/22156, rev 12 Using Parameter Editor
Figure 5-8 Parameter Editor, ROSS Example
Selection from the tree menu in the left panel of the window displays the appli-
cable parameters in the right panel, using a combination of text fields, pull-
down menus, check boxes, and radio buttons.
Configuration Changes
When changes are made to a unit configuration with Parameter Editor, these
changes are saved by clicking on the OK button at the bottom of the Editor
window. Alternatively, these changes are ignored by either clicking on the
Cancel button or closing the Editor window.
Caution: Clicking the OK button saves all of the data from all of the menu
category dialogs simultaneously to the ROSS unit Param file. The OK
and Cancel buttons do not apply to any single dialog, but apply to all
dialogs in the Parameter Editor.
Because the Parameter Editor closes after a save operation, it is recommended
that all desired changes be input prior to clicking on the OK button.
From the VMS ViperView user interface, ParamEdit is accessed by selecting the
ROSS Configure command (figure 5-2).
The following sections describe each of the tree menu items and their associated
configuration parameters and settings.