Comtech EF Data VMS v3.12.x Vipersat - Manual (Page 447)

Appendix C - Redundancy C-37
MN/22156, rev 12 N:M Hub Modem Redundancy
use this IP address, make certain that the IP address is on the Hub subnet and
is not being used by any other active or backup unit.
Figure C-36 Ethernet Interface page, CDM-570/570L
6. On the Vipersat Configuration page shown in figure C-37, set the Unit
Role to Hub Expansion.
7. This completes setting the unit to the Parked Configuration mode if it is a
CDM-564L. It is possible the unit was being used to supply voltage to a
LNB, which is described below.
Figure C-37 Vipersat Configuration page, CDM-570/570L
8. On the Satellite Modem Configuration > Configuration > Tx Config-
uration page shown in figure C-38, disable the unit’s transmit capability by
changing the Tx Carrier to [Off].