Comtech EF Data VMS v3.12.x Vipersat - Manual (Page 431)

Appendix C - Redundancy C-21
MN/22156, rev 12 N:M Hub Modem Redundancy
Redundancy Manager
The Device Redundancy Manager is loaded as a service in ViperView. By right-
clicking on it, as shown in figure C-14, the operator can enable device redun-
dancy, create the main container for the site, and backup or restore the redun-
dancy service.
Figure C-14 Redundancy Manager Drop-down Menu
Create Container
Selecting Create Container from the drop-down menu in figure C-14, brings
up the Create New Redundancy Group dialog shown in figure C-15. Clicking
the OK button creates a container with the name assigned in this dialog.
Figure C-15 Create Container dialog
Adding Strips and Groups
This top level container represents the main redundancy group. From it the
operator can add Power strips and Sub-groups by right-clicking on the newly
created Group icon and selecting from the drop-down menu shown in
figure C-16.