Comtech EF Data VMS v3.12.x Vipersat - Manual (Page 26)

How to Use This Manual MN/22156, rev 12
1-2 VMS User Guide
Chapter 3 — VMS Configuration
Covers the Quick Configuration procedure as well as detailed steps for full
System Configuration in building the Vipersat network.
Chapter 4 — Configuring Network Modems
Describes how VMS is used to configure modem/routers in the Vipersat
network. The use of Parameter Editor and its application to the Series800
modem/router is presented.
Chapter 5 — Configuring ROSS Units
Describes how VMS is used to configure ROSS units in the Vipersat network.
Device management in ViperView and the use of Parameter Editor for device
configuration is presented.
Chapter 6 — VMS Services
Describes the various service managers that comprise VMS and how Viper-
View is used to monitor and control the Vipersat network.
Chapter 7 — Out-of-Band Units
Describes the methods for integrating Out-of-Band modem units into a VMS-
controlled satellite network.
Appendix A — VMS Cross Banding
An explanation of how VMS accommodates applications involving satellite
cross strapping and cross banding.
Appendix B — Antenna Visibility
An explanation of how to use the VMS antenna visibility function to control the
frequency spectrum used in VMS switching.
Appendix C — Redundancy
Describes the optional redundancy services available for VMS—N:1 Server
redundancy and N:M Hub Modem redundancy.
Appendix D — SNMP Traps
Describes the use of SNMP traps by VMS.