Comtech EF Data VMS v3.12.x Vipersat - Manual (Page 268)

Network MN/22156, rev 12
4-50 VMS User Guide
Figure 4-32 Network Management dialog, CDM-800
Network ID
The Network ID designation defines to which Vipersat network the modem/
router belongs. All devices in a common network will have the same network
ID.
The network ID is used by the VMS to identify Vipersat units within a network
and allows the VMS to manage multiple networks, each with its own unique
network ID number.
Valid range is 1 to 254.
Base Port
The Base Port is the management port used by the VMS to send and receive
management UDP packets (see section “Vipersat Manager Configuration” on
page 3-12).
The Base Port sets the starting IP port addressing for all VMS messages. Chang-
ing this address base will affect the entire network, requiring configuration
changes to all modems. Leave this setting at default C000(hex)/49152(decimal)
to avoid unnecessary configuration changes. Altering this setting is ONLY
necessary if network port addressing is in contention.