Comtech EF Data VMS v3.12.x Vipersat - Manual (Page 143)

Chapter 3 - VMS Configuration 3-43
MN/22156, rev 12 Network Manager Configuration
Figure 3-42 Create Group menu command
2. Enter a Group Name in the Create Group dialog, then click OK.
Figure 3-43 Create Group dialog
3. Repeat the above steps to create additional group containers, as required.
Add Network/Group Satellite(s)
Satellites can be associated with either a Network or a Group by dragging from
RF Manager and dropping onto either element container. A satellite that is
placed at the Network level will be available to all Groups and Sites under that
network. A satellite that is placed at a Group level will only be available to the
Sites under that group.
Note that once a satellite is dropped onto an element, it can not then be dragged
out of that element and dropped onto another element, say from a Network to a
Group. The satellite must be removed from the first element, then dragged from
the RF Manager (the originating container) and dropped onto the other element.
1. Locate the satellite for this network/group in RF Manager, click-hold and
drag-and-drop it onto the network/group icon as shown in figure 3-44.