Comtech EF Data VMS v3.12.x Vipersat - Manual (Page 134)

RF Manager Configuration MN/22156, rev 12
3-34 VMS User Guide
between Remotes with smaller antennas. This is accomplished through
comparing its receive gain to the gain differences between Remotes.
During a mesh switch setup, the VMS compares the delta values and
modifies the power adjustments at each Remote site to compensate for
differences in receive gain. If DPC is enabled, the system will then further
fine tune power to the targeted configuration values.
If multiple Remotes are involved in a SHOD connection, the VMS uses the
lowest Remote gain value for compensation control.
4. Select the Visibility dialog to configure the Antenna Visibility range, as
shown in figure 3-31.
Caution: Unless specific limitations are required for the antenna range, the
recommended (default) settings are 500 GHz center frequency and
1 THz bandwidth (or, the equivalent, 0 Hz Base and 1 THz Top).
Refer to Appendix B, "Antenna Visibility", for more information on this
feature.
Figure 3-31 Antenna Visibility, Default Settings
5. Click on the OK button to complete the antenna creation.
The new antenna will appear under the satellite in the ViperView window.
6. Repeat the previous steps to create additional antennas.