Comtech EF Data VMS v3.12.x Vipersat - Manual (Page 119)

Chapter 3 - VMS Configuration 3-19
MN/22156, rev 12 Vipersat Manager Configuration
Figure 3-14 Server Properties, Auto Activate
The other parameters in this dialog pertain only to redundant server
configurations which will be addressed later (see “VMS Redundancy” on
page 3-110).
3. Click the Apply button to save this setting for the Server Properties, then
Close the window.
Auto-Discovery Process
Once Vipersat Manager is configured and the server is activated, communica-
tions between the VMS and live network units at Hub and Remote sites is estab-
lished, and the auto-discovery process begins. As Hub and Remote units are
identified, their appearance can be observed in ViperView under the Subnet
Manager and the Vipersat Manager by expanding the tree view, as shown in
figure 3-15.
Expand the tree view to display the list. If necessary, widen the left ViperView
window panel by repositioning the vertical divider to the right.