Comtech EF Data VMS v3.12.x Vipersat - Manual (Page 211)

Chapter 3 - VMS Configuration 3-111
MN/22156, rev 12 Network Manager Configuration
Figure 3-124 SOTM Transitioned Site
1. Open the Vipersat Map View and highlight the Network icon to make the
network active.
2. Right-click on a mobile Remote site and open the Properties window. Select
Position from the tree menu to display the Position Properties dialog
(figure 3-125).
Figure 3-125 Enable Dynamic Function for SOTM Remote
3. Check the Dynamic box and select the browse button beneath it. This will
open a dialog box in which the site antenna and subnet should appear
(figure 3-126).
Note that, if the subnet icon was not copied into this site as described in
Network Manager Configuration, it will not appear here.