Comtech EF Data VMS v3.12.x Vipersat - Manual (Page 476)

ToS Switching MN/22156, rev 12
E-20 VMS User Guide
Configuration
The ToS switching feature can be configured within the SLM-5650A modem
using either the CLI or the Web user interface. For simplicity, the Web interface
(figure E-10) will be presented in this example.
Figure E-10 Remote ToS Switching menu
The remote ToS switching is optioned by selecting 'Enable' or 'Disable'. In addi-
tion to the enable/disable control, the menu provides the ability to create a list of
ToS Rules for which a switch will be initiated. In defining these fields, certain
characteristics are created depicting what types of switch service connections
are established. These fields are described in table E-2.
Note: Load switching by the VMS is not affected by enabling ToS detection.
Table E-2 ToS Switching Settings
Field Values Description
Service Name Text (15 char max) A user defined ID association.
ToS ID 1 - 63 The ToS value for which a switch should occur. Note
that 0 can not be used to set a ToS based switch.
Switch Type 64 - 254 The type of Vipersat switch which will occur for this
ToS value.
SCPC Data Rate kbps The data rate for the switched SCPC link.
SCPC Timeout seconds The number of seconds of inactivity before the SCPC
circuit will be torn down.
NOTE