Comtech EF Data VMS v3.12.x Vipersat - Manual (Page 129)

Chapter 3 - VMS Configuration 3-29
MN/22156, rev 12 RF Manager Configuration
The visible frequency range is indicated by the frequency values displayed in
the lower left and lower right corners of the window. The dark area represents
the frequency range of the transponder that was created in the previous section,
and is labeled with the transponder name (Trans-1, in figure 3-24) in the upper
left corner. The gray areas are undefined satellite spectrum. The horizontal
wavy green line in the lower portion of the window represents the noise floor.
Note that the mouse pointer horizontal position within the window is displayed
as a frequency value at the bottom center of the window.
More information regarding the Spectrum View is provided in Chapter 6, "VMS
Services".
Create Bandwidth Pools
The next step is to create the bandwidth pools that define the available spectrum
for allocating to dSCPC carriers.
1. Right-click on the Satellite icon and select Properties from the drop-down
menu.
2. In the Satellite Properties window, select the Pools dialog, then click the
Create button and specify the Pool Range settings, as shown in figure 3-25.
Figure 3-25 Create Pool dialog