Comtech EF Data VMS v3.12.x Vipersat - Manual (Page 176)

Network Manager Configuration MN/22156, rev 12
3-76 VMS User Guide
Set InBand Application Policies
The establishment of Application Policies provides the rules and parameters
that are utilized for application switching operations in the Vipersat network.
Application switching is only available to those Remotes that have policy defi-
nitions associated with them, either directly (local policy) or via inheritance
(from network and/or group).
Vipersat network InBand Application Policy settings can be established at three
hierarchical levels within the Network Manager:
• The Network Level
• The Group Level
• The Site Level
This capability provides operators the ability to segregate application policies
between these three levels in the network. Policies for one network, group, or
site can be different from policies for another network, group, or site. Network
policies are inherited by the groups and sites that belong to that network, and
Group policies are inherited by the sites that belong to that group. Locally
created Site policies apply only to that site.
Start by building policies at the Network level, then set the policies at the Group
and/or Site levels.
1. Open the Network Properties and select the InBand Application Policies
dialog, as shown in figure 3-81.
Figure 3-81 InBand Application Policies dialog, Network
2. To add a policy, right-click in the table space and select Insert.
3. Enter the Type value, Label, Priority, and Bitrate limits for this policy
(figure 3-82), then click OK to enter this policy in the table .