Comtech EF Data VMS v3.12.x Vipersat - Manual (Page 315)

Chapter 6 - VMS Services 6-9
MN/22156, rev 12 ViperView—Monitor and Control
Using the Network Manager, right-clicking on a point in the network displays a
drop-down menu which is specific to the selected point in the network. From
this menu, the operator can perform any of the actions available on the list and
instantly modify the parameters of that network element.
An example is shown in figure 6-10 for a Remote data unit that displays an
alarm condition. Right-clicking on the modem and selecting Configure opens
the Configuration dialog (CDM-570L) shown in figure 6-11. Here, the correct
parameter settings can be verified and, if necessary, an image upgrade can be
performed.
Another example, shown in figure 6-12, shows a Hub expansion demodulator in
an alarm state due to reaching the maximum allocation failure count. Right-
clicking on the demodulator allows the count to be Reset via the menu
command that is presented.
Figure 6-10 Modem Configure Command