Comtech EF Data VMS v3.12.x Vipersat - Manual (Page 136)

RF Manager Configuration MN/22156, rev 12
3-36 VMS User Guide
Figure 3-33 Create Up Converter dialog
Also, check the Bandwidth and Power Limit settings. If the RF hardware
does not exactly match the satellite parameters, the Bandwidth setting may
have to be changed.
Contact the Vipersat Network Product Group CTAC for further information.
3. Click on OK to enter this device as the Up converter for this antenna.
4. Right-click on the Antenna icon again and select Create Down Converter.
5. The dialog box shown below (figure 3-34) will open. Specify a Name for
this device.
Ensure that the Frequency setting here also is correct.
6. Click on OK to enter this device as the Down converter for this antenna.