Comtech EF Data CTOG-250 - Manual (Page 91)

CTOG-250 Comtech Traffic Optimization Gateway Revision 1
Quick Start Guide MN-CTOG250
6–7
6.4 Adding a CTOG-250 to an Existing (Previously Deployed) CDM-800
Step Task
1 Remove all Ethernet cables from the existing CDM-800. Move the traffic Ethernet cables from the CDM-
800 to the ‘LAN TRAFFIC (1)’ and (if necessary) ‘LAN Traffic (2)’ ports on the CTOG-250.
2 Assign a M anagement I P A ddress to t he C TOG-250 t hat i s on the ex isting C DM-800’s m anagement
network.
3 Verify that the CTOG-250 is on the same network and cabled correctly by issuing a ping from the User PC
to the CTOG-250.
4 Connect a CAT5 Ethernet cable from the ‘WAN’ port on the CTOG-250 chassis back panel to the ‘GE1’
port on the CDM-800 rear panel.
5 Upon power-up and bootup of the CTOG-250 system, the CTOG-250 checks the firmware version of the
CDM-800. I f t he v ersion i s not correct, t he C TOG-250 upgr ades t he C DM-800’s f irmware, and t hen
performs a reboot of the CDM-800 to load the new firmware.
6 Upload t he ex isting C DM-800’s c onfiguration t o t he C TOG-250 v ia t he [Sync Configuration From
CDM-800] button on the CTOG-250 Web Server Interface Utility | CTOG-250 Unit page.
Chapter 7.ETHERNET-BASED REMOTE PRODUCT MANAGEMENT
7
Ping the CDM840’s traffic IP. If the ping is unsucessful, check all cables and r outing information and try
again.