beautypg.com

2 automatic cdm-800 configuration, 3 ctog-250 serial interface – Comtech EF Data CTOG-250 User Manual

Page 89

background image

CTOG-250 Comtech Traffic Optimization Gateway

Revision 1

Quick Start Guide

MN-CTOG250

6–5

6.3.2 Automatic CDM-800 Configuration

Upon power-up and bootup of the CTOG-250 system, the CTOG-250 checks the firmware

version of the CDM-800. If the version is not correct, the CTOG-250 upgrades the CDM-800’s

firmware, and then performs a reboot of the CDM-800 to load the new firmware.

Results of the upgrade process may be reviewed using the CTOG-250 Web Server

Interface STATUS | MONITOR page.

Chapter 7.ETHERNET-BASED REMOTE PRODUCT MANAGEMENT

6.3.3 CTOG-250 Serial Interface

Step Task

1

From the Windows-based User PC: Launch a terminal emulation program (e.g., HyperTerminal, Tera

Term, etc.)

2

Select the appropriate COM port (i.e., the port to which the DB-9 end of the cable are connected) and

configure it for:

38,400 bps

8 data bits

No parity

1 stop bit

No hardware flow control

3

Type “info” and press enter to display the CTOG-250 Serial Interface as shown here:

Note that if the terminal is not set to “Echo”, any input to the terminal will not be displayed when typing but

will be received by the CTOG-250.