Comtech EF Data CTOG-250 - Manual (Page 145)

CTOG-250 Comtech Traffic Optimization Gateway Revision 1
Ethernet-based Remote Product Management MN-CTOG250
7–43
Column Description
Rx Target Es/No
Margin (dB) (cont.)
On the other hand, a large Tx Target Margin allows the ACM
Controller to adapt before packet are dropped, but when the link is
not fading quickly a lower amount of data (resulting in a higher
MODCOD) will be available for that remote.
The indicated number is the measured Es/No with 0.5 db Margin
added to it. A value of at least 1db is recommended.
Time Last Report
(sec)
Amount of time, in seconds, since the Link Quality (Es/No) was last reported by the
CDM-840.
Max Time, Last
Report (sec)
Maximum time period, in seconds, that has expired in any cycle since the CDM-840
last reported its Link Quality (Es/No).
Click [Submit] to save any changes made in this section.
Click [Delete] to delete this specific site entry. The prompt “Do you want to delete this site?”
appears. Click [OK] to continue, or click the [X] to cancel this action.
1. Deleting a site also causes the CDRP associated routes to be deleted. The Site
will also be removed from all of the QoS Groups.
2. If a remote has not reported to the CTOG-250 in longer than the “Site
Removal Timeout”, it will be automatically removed from the Remote list.
3. If the remote still exists and has communication with the CTOG-250
Management Interface, the remote will be automatically re-added.