Comtech EF Data CTOG-250 - Manual (Page 102)

CTOG-250 Comtech Traffic Optimization Gateway Revision 1
Quick Start Guide MN-CTOG250
6–18
6.6.1.2 Configuring the CTOG-250 for VMS-enabled N:M Redundancy
Consult adjunct Comtech EF Data publication MN/22156 Vipersat VMS v3.9.x
Vipersat Management System User Guide when using this section of the Quick
Start Guide chapter.
1. Once devices have been installed in the Advanced VSAT Network as shown in Figure 6-4,
refer to MN/22156 Appendix C – Redundancy subsection “N:M Hub Modem Redundancy
|Installing N:M Redundancy”.
All units in both the primary and secondary group must be identical, with exactly the
same hardware configuration and accessories, and have identical firmware revision
levels.
2. To complete configuration, follow the procedures referred to in MN/22156 Appendix C –
Redundancy
6.7 Getting Help with the CTOG-250 Configuration
subsection “N:M Hub Modem Redundancy | Setting Up N:M Redundancy”.
For all product support, please call:
+1.240.243.1880
+1.866.472.3963 (toll free USA)