Comtech EF Data CTOG-250 - Manual (Page 147)

CTOG-250 Comtech Traffic Optimization Gateway Revision 1
Ethernet-based Remote Product Management MN-CTOG250
7–45
7.4.4.3.2.5 Configuration | WAN | BUC (Block Up Converter)
Use this page to configure Block Up Converter parameters, and display the BUC status for
L-Band operation.
Figure 7-19. Configuration | WAN | BUC page
BUC Control
• BUC Power Supply and BUC 10 MHz Ref Enable – Use the drop down menus to turn these
functions ON or OFF.
• BUC Low and High Current Limit – Assign a value for each (in mA) ranging from 0 to 4000.
Click [Submit BUC Controls] once the desired configuration settings have been made in this
section.
BUC Status
This section refreshes automatically every ten seconds. These status parameters are read-only
and cannot be changed.
Click [Refresh] to update this section with current information.