Comtech EF Data CTOG-250 - Manual (Page 172)

CTOG-250 Comtech Traffic Optimization Gateway Revision 1
Ethernet-based Remote Product Management MN-CTOG250
7–70
Save/Load Configuration
This section allows you to save, and then load (recall) up to 10 configuration sets:
• To save a configuration set:
o First, adjust all operational configuration parameters to suit.
o Then, use the top (Save) Select Location dropdown to select 1 through 10.
o Finally, click [Save Configuration] to store the configuration settings.
• To load (recall) a configuration set:
o First, use the bottom (Load) Select Location dropdown to select 1 through 10.
o Then, click [Load Configuration] to recall the selected configuration settings.
BERT Config
(Where BERT is the acronym for Bit Error Rate Test) Use the drop-down menus to:
• Configure the Tx BERT State as On or Off.
• Configure the Tx or Rx BERT Pattern as 2^23-1 (2 23 -1) or 2047.
• Set Error Insert(ion) as either Off or 10E-3.
Click [Submit] to save the BERT settings and execute the test.
Once the Tx BERT is executed, the entire outbound carrier transmits a BERT pattern.
All IP communications are halted during this test.
Note also that the Rx BERT State for the CDM-840 Remote Router must be enabled
to properly receive and monitor the BERT pattern.
Redundancy (FUTURE)
THE REDUNDANCY FEATURE IS A FUTURE OFFERING. THIS SECTION IS NON-
FUNCTIONAL AT THIS TIME.