Comtech EF Data CTOG-250 - Manual (Page 148)

CTOG-250 Comtech Traffic Optimization Gateway Revision 1
Ethernet-based Remote Product Management MN-CTOG250
7–46
7.4.4.3.3 Configuration | Network pages
Precision Time Protocol is not available in this firmware release. The PTP tab, while
available and selectable on this interface, is therefore non-functional.
7.4.4.3.3.1 Configuration | Network | Routing
Use this page to configure routing for IP traffic over the satellite or to another device on the
LAN.
Figure 7-20. Configuration | Routing | Routes page
The CTOG-250 supports two types of routing: Dynamic and Manual.
When operating a network in Bridge Point-to-Multipoint (BPM) mode, user traffic
will pass through the various traffic ports, however, the management of the
network is required to be through the routed Management Network.
Comtech Dynamic Routing Protocol (CDRP) is provided to greatly reduce the complexity of
deploying Comtech EF Data’s Advanced VSAT solution in an IP-routed network.