Comtech EF Data CTOG-250 - Manual (Page 104)

CTOG-250 Comtech Traffic Optimization Gateway Revision 1
Ethernet-based Remote Product Management MN-CTOG250
7–2
7.2 Ethernet Management Interface Protocols
The user PC affords access to Ethernet-based remote monitor and control (M&C) of the CTOG-
250 through two separately operated protocols:
• Simple Network Management Protocol (SNMP). This non-secure interface requires a user-
supplied Network Management System (NMS) and a user-supplied Management Information
Base (MIB) File Browser.
• The CTOG-250 Web Server (HTTP) Interface. This non-secure interface requires a compatible
user-supplied Web browser such as Internet Explorer.
7.2.1 Ethernet Management Interface Access
See Chapter 8. SERIAL-BASED REMOTE PRODUCT MANAGEMENT for details on
setting up and using the CTOG-250 Serial Interface.
Access to the CTOG-250 Ethernet Management Interface requires that you specify the unit
Management IP Address. Via use of a terminal emulator connected to the back panel 9-pin serial
‘SERIAL’ port, this address may be obtained from the CTOG-250 Serial Interface upon power-up
of the unit. As shown, a number of operational parameters (including the factory-default IP
addresses) are displayed.
The factory-assigned default IP addresses are provided in the table that follows (if otherwise
assigned, you may use the last column to write down the IP Addresses for future reference):
Description Default Address User-assigned Address
Management 192.1.1.1 ________________________
Traffic-1 192.1.2.1 ________________________