Comtech EF Data CTOG-250 - Manual (Page 119)

CTOG-250 Comtech Traffic Optimization Gateway Revision 1
Ethernet-based Remote Product Management MN-CTOG250
7–17
7.4.4.2.6 Admin | VMS
VMS v3.x.x VIPERSAT Management System User Guide (CEFD P/N MN/22156)
Figure 7-8. Admin | VMS page
Vipersat Management System Configuration
The acceptable/valid operating ranges for items in this section are provided in parentheses.
• Network ID (1-255) –The Network ID designation defines to which network the Gateway
Router belongs. All devices in a common network will have the same network ID. The
network ID is used by the VMS to identify Vipersat units within a network and allows the
VMS to manage multiple networks, each with its own unique network ID number.
• Management Base Port – The Management Base Port sets the starting IP port addressing
for all VM, ACM, and CDRP messages.
• Use this setting ONLY
• Changing this port number will affect internal management operations
across the entire network, requiring configuration changes
if network port addressing is in contention.
Otherwise, leave this setting at default (hex) C000 (des) 49152 to avoid
unnecessary configuration changes.
to all modems
• While this page is operational only when the optional VIPERSAT
MANAGEMENT SYSTEM (VMS) is installed and operational, the
Management Base Port number is essential to proper operations with or
without the VMS feature.
.