Comtech EF Data CTOG-250 - Manual (Page 181)

CTOG-250 Comtech Traffic Optimization Gateway Revision 1
Serial-based Remote Product Management MN-CTOG250
8–5
8.2.2.2 Target Address
In EIA-232 applications, this value is set to 0000.
The Target Address designates the packet destination. The Controller does not have its own address. After the
Controller sends a packet with the designated Target Address, the Target responds to the Controller, using this
same address, to indicate the source of the packet.
8.2.2.3 Address Delimiter
This is the “forward slash” character '/ ' (ASCII code 47).
8.2.2.4 Instruction Code
This three-character alphabetic sequence identifies the message subject.
Wherever possible, the instruction codes have been defined to have some significance – e.g., MLC for Management Link Configuration,
IPA for Management IP Address, etc. This aids in the readability of the message, should it be displayed in its raw ASCII form.
Only upper case alphabetic characters may be used (‘A’ to ‘Z’, ASCII codes 65 - 90).