Comtech EF Data CTOG-250 User Manual
Page 231

CTOG-250 Comtech Traffic Optimization Gateway
Revision 1
Appendix E
MN-CTOG250
E–9
E.3
Configuring, Operating, and Monitoring Outbound ACM
See Chapter 7. ETHERNET-BASED REMOTE PRODUCT MANAGEMENT for detailed
information on using the CTOG-250 Web Server Interface.
Use the following CTOG-250 Web Server Interface pages for the configuration, operation, and
monitoring of Outbound ACM:
• Configuration | Network | Routing
• Configuration | WAN | Mod
• Configuration |WAN| Remote Site |
Remote Site Event Log
• Status | Statistics | Outbound
E.3.1 Prerequisites for CDM-800 Outbound ACM Operation via the CTOG-250
Sect. 7.4.4.3.3.1 Configuration | Network | Routing
You must enable Comtech Dynamic Routing Protocol (CDRP) using the Configuration |
Network | Routing page. You are required to enable this feature because the ACM Controller
uses the remote to route mapping provided by CDRP to properly determine the required
MODCOD upon which to transport the packets destined to each remote.
Figure E-4. Configuration | Network | Routing page