Comtech EF Data CTOG-250 - Manual (Page 121)

CTOG-250 Comtech Traffic Optimization Gateway Revision 1
Ethernet-based Remote Product Management MN-CTOG250
7–19
7.4.4.3 Configuration Pages
Use these nested pages to configure all operating parameters for both the ‘parent’ CTOG-250
and the ‘child’ CDM-800.
Click the Configuration tab, and then select the Interface, WAN, or Network tab to continue.
7.4.4.3.1 Configuration | Interface Pages
The CTOG-250 back panel Expansion Traffic (2) Port is not used and is typically left
disconnected. The EXP-NET2 tab, while selectable, is therefore non-functional in
this firmware release.
Click the Configuration | Interface tabs, and then select the MGMT, LAN-1, LAN-2, EXP-NET1 or
WAN tab to continue.
7.4.4.3.1.1 Configuration | Interface | MGMT
Use this page to configure the back panel ‘MGMT-1’ 10/100/1000 BaseT Gigabit Ethernet M&C
port. Note that this port serves as the dedicated Ethernet-based monitor and control interface
between the ‘parent’ CTOG-250 / ‘child’ CDM-800 Gateway Router and the user PC.
Figure 7-9. Configuration | Interface | Mgt Page
FE – Management Interface
The acceptable/valid operating ranges for items in this section are provided in parentheses.
• MAC Address (read-only) – The Ethernet MAC Addresses are configured at the factory and
cannot be changed. This address is unique for each port.