Comtech EF Data CTOG-250 User Manual
Page 161

CTOG-250 Comtech Traffic Optimization Gateway
Revision 1
Ethernet-based Remote Product Management
MN-CTOG250
7–59
The Statistics, Total For All Groups, and Group Table sections are typical for all QoS
Control Mode settings.
Statistics
Click [Clear] to clear all operational statistics from the buffer, or [Refresh] to update the tables
on this page with their most recently acquired statistics.
Total For All Groups
See the Configuration | WAN | QoS page (Sect. 7.4.4.3.2.2) for the definition of the terms used
in this table.
Group Table
This section is active only when QoS Control Mode is set to DiffServ.
See the Configuration | WAN | QoS page (Sect. 7.4.4.3.2.2) for the definition of the terms used
in this table.
Click Select to activate a desired group (when more than one group has been created). Otherwise,
if only a single group is found, operation defaults to this selection.
QoS Statistics
The appearance of the QoS Statistics section differs depending on the active page
configuration. See the Configuration | WAN | QoS page (Sect. 7.4.4.3.2.2) for the
definition of the terms used in this table.
When QoS Control Mode is set to Off, Max/Pri or Min/Max: