Comtech EF Data CTOG-250 - Manual (Page 118)

CTOG-250 Comtech Traffic Optimization Gateway Revision 1
Ethernet-based Remote Product Management MN-CTOG250
7–16
Firmware Configuration
Use the Boot From: drop-down menu to select Latest, Slot 1, or Slot 2. The default selection is
Latest, in which the CTOG-250 will automatically select the image that contains the most current
firmware.
Click [Submit] when done. Note that the Slot Information section, which in Figure 7-6 displays
Slot #1 as the designated active running firmware image, will not update until after the system
is rebooted.
System Reboot
Click [Reboot] to reboot the CTOG-250. Once the unit reboots, you must log in once again to
resume use of the Web Server Interface. See the Utility | Reboot page (Sect.7.4.4.5.3) for full
details about the reboot process.
7.4.4.2.5 Admin | Auto Logout
Use this page to execute the Auto Logout security measure. With Auto Logout configured, the
active session terminates if the unit remains idle (i.e., when no user activity occurs) beyond the
assigned Logout Time. A valid user name and password is then required to resume the
CTOG-250 Web Server Interface session.
Figure 7-7. Admin | Auto Logout page
Auto Logout Configuration
Set an automatic logout time to safeguard access to an already logged-in unit:
• Enter a time value from 1 to 15 minutes into the Logout Time box to configure this feature.
• Enter a value of 0 to disable this feature.
Click [Submit] to save.