Comtech EF Data CTOG-250 - Manual (Page 72)

CTOG-250 Comtech Traffic Optimization Gateway Revision 1
Updating Firmware MN-CTOG250
4–2
4.2 Getting Started: Preparing for the Firmware Download
1. First, identify the CTOG-250 assigned Management IP Address, and the firmware number/
revision letter/version number.
User-supplied items needed:
• A Microsoft Windows-based PC, equipped with available serial and Ethernet ports; a
compatible Web browser (e.g., Internet Explorer); and a terminal emulator program
(e.g., Tera Term or HyperTerminal).
• A 9-pin serial cable to connect the PC to the CTOG-250.
A. Use the 9-pin serial cable to
connect the CTOG-250 ‘SERIAL’
port to a serial port on the user
PC:
B. On the PC: Open the terminal emulator program.
Refer to your terminal emulator program HELP feature or user guide for
operating and configuration instructions.
Configure the utility program serial port communication and terminal display operation:
• 38400 bps (Baud Rate) • 8 Data Bits • 1 Stop Bit
• Parity = NO • Port Flow Control = NONE • Display New line Rx/Tx: CR
• Local Echo = ON
C. On the CTOG-250: Turn on the power from the
chassis front panel.
D. On the PC: Review and record the information displayed on the CTOG-250 Serial
Interface:
• Management IP Address (e.g., default is 192.168.1.2/24)
• Firmware Number and Revision Letter (e.g., FW-0020601G)
• Firmware Release Version (e.g., 1.5.1)