Comtech EF Data CTOG-250 - Manual (Page 140)

CTOG-250 Comtech Traffic Optimization Gateway Revision 1
Ethernet-based Remote Product Management MN-CTOG250
7–38
Column Description
Min BW (Kbps)
(Min/Max mode only)
Max BW (Kbps)
The bandwidth values are displayed in these columns.
Priority
(Max/Pri(ority) mode only)
The priority established for the specific rule is identified here.
WRED (Weighted Random Early Detection) The WRED setting for the specific rule is
identified here as Disable or Enable. When WRED is enabled, the QoS Queue
will attempt to smoothly drop packets as the queue becomes congested. This is
recommended for queues that will carry TCP packets.
Filter All The flow filter setting for the specific rule is identified here as Disable or Enable.
Add / Delete Per Group QoS Rule
Refer to the QoS Rules Per Group (Edit)Table section for the description of each column.
•
To delete an existing rule: For either page, Enter Rule Index to Delete. Click [Delete Rule]
when done. This deletes the specified entry from the QoS Rules Per Group Table.
• To add a new rule: For either page, enter or select the desired information. Click [Add Rule]
when done. The index will automatically increment to the next available number when the
new rule is added.
• In ‘Max/Pri(ority)’ mode:
From left to right:
Column Description
Priority To define a priority, use the drop-down list to designate a priority for this rule
from 1 (Highest) to 8 (Lowest). The QoS system allows multiple QoS rules to
have the same priority. When QoS rules are set with the same priority, they
are serviced on a time-sharing “Round-robin” (time-sharing) basis.
WRED Use the drop-down list to set Weighted Random Early Detection as Enable or
Disable. When WRED is enab led, the QoS Queue will attempt to smoothly
drop pac kets as t he queue becomes congested. This i s r ecommended for
queues that will carry TCP packets.
Filter All Use the drop-down list to set the flow filter setting as Disable or Enable.
• in ‘Min/Max’ mode: