Comtech EF Data CTOG-250 - Manual (Page 175)

CTOG-250 Comtech Traffic Optimization Gateway Revision 1
Ethernet-based Remote Product Management MN-CTOG250
7–73
7.4.4.5.3 Utility | Reboot
Use this page to perform a soft reboot of the CTOG-250 or the CDM-800. Note that the function
of the CTOG-250 Only Reboot section of this page is identical to the System Reboot section of
the Admin | Firmware page described earlier.
Figure 7-33. Utility | Reboot page
CTOG-250 Only Reboot
Click [Reboot]. A dialogue box appears to prompt continuation or
cancellation of the reboot process:
Click [OK] to continue the reboot process, or [Cancel] to abort the process and resume use of
the Utility | Reboot page.
Once the reboot process resumes, the Utility | Reboot page is replaced with the dynamic
message “Please wait... CTOG-250 is rebooting. Login will be required in XX seconds” – the
time count decrements to 0 seconds before the unit reboots. After the reboot, login is required
once again to resume use of the Web Server Interface.
CDM-800 Only Reboot
Click [Reboot]. A dialogue box appears to prompt
continuation or cancellation of the reboot process:
Click [OK] to transparently continue the reboot process, or [Cancel] to abort the process and
resume use of the Utility | Reboot page. As the dialogue box message indicates, the reboot is
complete once the Virtual Front Panel CDM-800 COMM’S LED changes from red to green.