AMETEK i Series - Manual (Page 87)

User Manual
i Series / iX Series 73
4.2.11.5 CONFIGURATION SETUP screen
The configuration setup screen is not a menu but only serves to inform the user of the software
options installed in the AC source. The cursor can be moved to any of the fields in this screen but
none of these fields can be changed. The following information is provided on this screen:
Entry Description
NO. OUTPUT [iX Series only] Displays the phase mode option. SELECT
indicates the phase mode option is installed and the user can
select between single and three phase modes of operation. The
phase mode option is only available on the 15003iX model.
FIXED indicates the phase mode option is not installed and only
single phase or three phase mode of operation is possible.
ADVANCE [iX Series only] For iX Series models, this field is always set to
ON to indicate the advanced capabilities for waveform
generation and measurement analysis are present. On i Series
AC sources, this field is always set to N/A (not available).
DO160D Indicates the presence of the RTCA DO160D test option. If this
option is installed, this field will show ON. If this option is not
installed, this field will show N/A (not available).
MIL704D Indicates the presence of the MIL/STD-704D test option. If this
option is installed, this field will show ON. If this option is not
installed, this field will show N/A (not available).
IEC1000-4-11 Indicates the presence of the IEC 1000-4-11 test option. If this
option is installed, this field will show ON. If this option is not
installed, this field will show N/A (not available).
IEC1000-4-13 Indicates the presence of the IEC 1000-4-13 test option. If this
option is installed, this field will show ON. If this option is not
installed, this field will show N/A (not available).