AMETEK i Series - Manual (Page 117)

User Manual
i Series / iX Series 103
5.3.2 Keyboard/Display Board
The keyboard/display assembly is assembly A9. It is mounted to the front panel and holds the 23
rubber keys. It also has the LCD graphics display. A shaft encoder is mounted on the board that
is used for a shuttle input.
5.3.3 Phase B and C Board
This assembly, A8, has the waveform, measurement and impedance programming components
for the Phase B and C outputs. This board is only installed for a 15003iX power system, with one
controller for the Master Phase A power source.
5.3.4 GPIB/RS232 Board
This board assembly is identified as A10. It has the IEEE 488 and RS232 transceivers. It also
has optocouplers for both interfaces.