AMETEK i Series - Manual (Page 171)

User Manual
i Series / iX Series 157
In addition to the three tab controls, the left pane of the 160 window contains a set of output
on/off control buttons and a print button. The on/off buttons may be used to open or close the
output relay of the power source at any time. If the output relay is opened during a test run, the
test is automatically aborted when the operator clicks on the Off button. The ON button will be
shown in red while the output relay is closed. The Off button is shown in green if the output relay
is open. The report print function can be invoked by either clicking on the Print button or using
the File, Print menu.
If the GUI program is used in demo mode, the “DEMO MODE ONLY!!!” banner will be displayed
in this area as well. In Demo mode, all test runs and all measurements are simulated. This
mode may be used to develop new test sequences off-line but any run-time errors will not be
detected until executed with an actual power source.
9.1.2.7 160 Menus
The top of the 160 window contains a standard Windows menu bar. Available menus are:
Menu Sub Menu Description
File New The selected clears all data from the Test Control data grid. This
operation is not normally recommended unless a complete new test
sequence is to be entered manually.
Open Opens a specific test sequence file. This menu may be used to directly
select a test file without using the Test Selection table tab.
Save Saves the contents of the test sequence data grid to the selected test
file.
Save As… Saves the contents of the test sequence data grid to a user defined file
name. A file dialog box will appear enabling selection of the directory
and file name under which to store the contents of the test sequence
data grid.
Print Prints a test report using MS Word format. Only data for the presently
selected test sequence is printed. The test reports also include EUT
performance measurement data.
Note: To print reports, the MS Word report format selection must be
made from the Main GUI, Options menu  Report Format menu before
opening the 160 test screen. If not, an error prompt will indicate that no
supported report format is selected.
Exit Closes the 160 test window.
Edit Cut Cuts the selected row from either the Test selection data grid or the
Test sequence data grid. The data in the row cut is available for a Paste
operation.
Copy Copies the selected row from either the Test selection data grid or the
Test sequence data grid. Copied rows can be pasted to the same grid at
a different location.
Paste Pastes a copied row from to either the Test selection data grid or the
Test sequence data grid.
Insert Row Inserts a new blank row at the selected data grid location.
Delete Row Deletes the selected row from either the Test selection data grid or the
Test sequence data grid. The row contents are permanently discarded.
Run All Run selected test
Stop Abort test in progress
Help Opens the on-line help file.