AMETEK i Series - Manual (Page 266)

User Manual
252 i Series / iX Series
This manual is not intended to elaborate on the intent or purpose of the immunity tests and the
expected behavior of the EUT as described in the MIL-STD-704 documents. It is assumed that
the end-user is familiar with the content of the MIL-STD-704 test standard.
9.8.2.2 Test Coverage
The comprehensiveness of the test that can be performed with the –704 option is determined
primarily by the capabilities of the power source used. Tests that are outside the hardware
capabilities of the power source used will not be enabled and cannot be selected. For these
tests, additional equipment may be required as indicated. The extent of coverage of the
–704
option as implemented on the IX Series platform is shown in the table below. Tests marked with
an „x‟ generally require additional hardware to be used. Tests marked „N/A‟ are not applicable to
the corresponding table. Tests marked with a „ ‟ are covered by at least one rev of the MIL-STD-
704.
No. Description Table
SAC
Table
TAC
Table
SVF
Table
TVF
Table
SXF
No. Description Table
LDC
Table
HDC
101
Load and Current
Harmonic
Measurements
101 Load Measurements
102
Steady State Limits
for Voltage and
Frequency
102
Steady State Limits for
Voltage
103
Voltage Phase
Difference
N/A N/A N/A 103
Voltage Distortion
Spectrum
X X
104 Voltage Modulation 104 Total Ripple X X
105 Frequency Modulation 105
Normal Voltage
Transients
1
106
Voltage Distortion
Spectrum
X X X X X 201 Power Interrupt
107
Total Voltage
Distortion
301
Abnormal Steady State
Limits for Voltage
108
DC Voltage
Component
302
Abnormal Voltage
Transients
2
109
Normal Voltage
Transients
401
Emergency Limits for
Voltage
110
Normal Frequency
Transients
501
Starting Voltage
Transients
201 Power Interrupt 601 Power Failure
301
Abnormal Steady
State Limits for
Voltage and Freq.
602 Polarity Reversal
302
Abnormal Voltage
Transients
303
Abnormal Frequency
Transients
401
Emergency Steady
State Limits for
Voltage and Freq.
501 Starting Voltage N/A N/A N/A N/A N/A
1
Note: Some restrictions apply due to voltage range limitations. See section 9.8.2.3 for details.
2 Note: Some restrictions apply due to voltage range limitations. See section 9.8.2.3 for details.