AMETEK i Series - Manual (Page 228)

User Manual
214 i Series / iX Series
9.5 Mode iX Option
9.5.1 Introduction
This section contains information on the installation and operation of the Mode-iX phase mode
controller to be used with the California Instruments iX-series of power sources.
GENERAL DESCRIPTION
The Mode-iX phase mode controller accepts three outputs from California Instruments iX-series
power systems and directs them to one output for a single phase system or three outputs for a
three phase system. This switching action is performed automatically via a control signal from
the power system to the Mode-iX phase mode controller.
9.5.2 Specifications
9.5.2.1 Input
Line Voltage
(user configurable) 115 VAC ±10%
230 VAC ±10%
Line Current < 0.25 amps at 115 VAC input
< 0.125 amps at 230 VAC input
Line Frequency 47 to 63 Hz
Fuse Rating 0.25 amp, slow acting at 115 VAC input
0.125 amp, slow acting at 230 VAC input
9.5.2.2 Phase Mode Terminals
Voltage 300 volts line to chassis
600 volts line to line
Current 37A rms, SOURCE A, B, C, N
37A rms, LOAD B, C
112A rms, LOAD A, N
9.5.2.3 Controls/Indicators
ON/OFF toggle switch
Phase mode push button switch
Power lamp
One Phase Mode lamp
Three Phase Mode lamp