AMETEK i Series - Manual (Page 277)

User Manual
i Series / iX Series 263
Control / Display Description
Dwell Dwell time in seconds.
Loop Repeat count for each step. Default is 1.
Link Number of subsequent rows that are linked to this step. This
function is required to implement complex transients that require
multiple steps with zero time skew. When set to a value other
than blank or “0”, subsequent rows are considered part of the
same test step for single step or loop on step execution modes.
PhsB Phase angle of phase B, only visible if phase angle is changed.
PhsC Phase angle of phase C, only visible if phase angle is changed.
Comment A comment about the specific test step.