EXFO RTU 310-310G IP Services Test Head - Manual (Page 98)

Creating and Starting a Test Case
86 FTB-8500 Series and FTB-8120NGE/8130NGE
Ethernet EtherSAM (Y.1564) and RFC 2544 Dual Test Set Test Cases
1c. From the Remote Module page, click the Remote Selection
button.
1d. If both modules (remote and local) are on the same subnet,
select the subnet mask (Broadcast Destination) of the network
to be scanned, based on the IP address and subnet of its
interface. Available with IPv4 only.
If the remote and local modules are not on the same subnet, like
when connected through a Router, enter the remote module IP
address in the IP Address field of the Remote Module
Connection section. For IPv6, entering a Global IPv6 destination
address requires that the interface Global IPv6 Address is
defined. The Remote ID and its Status are displayed if the module
is detected. Skip to step 1g.
IPv4 IPv6