EXFO RTU 310-310G IP Services Test Head - Manual (Page 124)

Creating and Starting a Test Case
112 FTB-8500 Series and FTB-8120NGE/8130NGE
Ethernet Smart Loopback Test Case
3. Framing configuration:
3a. Set the
Auto-Negotiation,
Speed, Duplex, and
Flow Control
parameters. Refer to
Interface Setup
(Ethernet) on page 142
for more information.
3b. Select the Frame
Format. Choices are
Ethernet II and
802.3 SNAP. Refer to
Network on page 150 for
more information.
3c. Set the IP Version(IPv4 or IPv6) IP Version is only available when
the IPv6 software option (SK-IPV6) is enabled.
3d. Set the IP Address, Enable DHCP, Subnet Mask, and Default
Gateway parameters. Refer to Source IP Configuration on
page 152 for more information.
3e. Click Finish to complete the test setup. The Alarm summary tab
is automatically displayed.
4. Click the Start button to start the test.
5. For additional results, refer to Traffic Analyzer Tabs on page 199.