EXFO RTU 310-310G IP Services Test Head - Manual (Page 501)

Pop-Up Windows
Ethernet and Fibre Channel Application 489
IPv4 Configuration
IPv4 Configuration
Source
Note: For EtherSAM Dual Test Set, the source IP address is only configurable
through the Network on page 150.

Automatic IP Address:
Allows to dynamically obtain
an IP address from a DHCP
(Dynamic Host
Configuration Protocol)
server.

IP Address: Enter the IP
address for the selected
service. The default setting is 10.10.x.x, where x and y are respectively
the two least significant bytes of the port default MAC address.

Subnet Mask: Enter the Subnet Mask for the selected service. The
default setting is 255.255.0.0.
Destination

IP Address: Enter the destination IP address for the selected service.

Ping button: Click Ping to automatically start the quick Ping utility for
the service destination IP address using the Ping parameters from the
Setup on page 412. Refer to Ping on page 508 for more information.

Default Gateway: Enter the default Gateway IP address. Enable Default
Gateway must be activated to enable the Default Gateway IP address
field. The default setting is 0.0.0.0.

Enable: Allows enabling the Default Gateway.