EXFO RTU 310-310G IP Services Test Head - Manual (Page 378)

Expert Mode Tabs
366 FTB-8500 Series and FTB-8120NGE/8130NGE
Throughput (RFC 2544)
Throughput (RFC 2544)
Click TEST, Expert Mode, and Throughput.

Enable Criteria: Allows to enable Throughput Pass/Fail criteria. This
setting is disabled by default.
Note: Both Enable Criteria and the test itself (see Global Configuration on
page 296) have to be enabled for a specific test to be able to change its
criteria values.

Frame Size: Indicates the frame sizes selected for the test.

TX-to-RXP1-to-P2/P2-to-P1/Local to Remote/Remote to Local: For
each frame size, enter the minimum throughput values allowed before
declaring a Fail condition. The default values are the maximum
throughput. P1-to-P2/P2-to-P1 is only available with RTU-310.

Status: Indicates the real-time pass/fail condition.
Grey LED: Indicates that Expert Mode is disabled or the test did not
run yet.
Green LED: Indicates that the threshold is respected (Pass).
Red LED: Indicates that the threshold is not respected (Fail).

Copy From Measurement button: Copy the performance results from
the test that ran previously and use it as the Pass/Fail criteria. If no test
ran before, default values used will be 0 bps.

Unit: Select the unit. Choices are: bps, Kbps, Mbps, Bps, KBps, MBps,
Gbps, GBps, % Util and fps (Frame Per Second). The default setting is
bps.