EXFO RTU 310-310G IP Services Test Head - Manual (Page 164)

Port Tabs
152 FTB-8500 Series and FTB-8120NGE/8130NGE
Network
Source IP Configuration
For IPv4:

Automatic IP Address: Allows to dynamically obtain an IP address
from a DHCP (Dynamic Host Configuration Protocol) server.

IP Address: Enter the IP address for the Ethernet port. The default IP
address is the address set from the Default/Ethernet Test Preferences
on page 336. The default factory IP address from the Default Test
Preferences is 10.10.x.y, where x and y are respectively the two least
significant bytes of the port default factory MAC address.

Subnet Mask: Enter the Subnet Mask for the Ethernet port. The default
setting is 255.255.0.0.

Default Gateway: Enter the default gateway address for the Ethernet
port. The default setting is 0.0.0.0.
Enable: Allows enabling and editing the default gateway IP address.
This setting is disabled by default.
Note: IP Address and Subnet Mask are not available when the Automatic IP
Address check box is selected. However, the IP Address obtained from the
DHCP server will be displayed in the IP Address field.