EXFO RTU 310-310G IP Services Test Head - Manual (Page 380)

Expert Mode Tabs
368 FTB-8500 Series and FTB-8120NGE/8130NGE
Back-to-Back (RFC 2544)
Back-to-Back (RFC 2544)
Click TEST, Expert Mode, and Back-to-Back.

Enable Criteria: Allows to enable Back-to-Back Pass/Fail criteria. This
setting is disabled by default.
Note: Both Enable Criteria and the test itself (see Global Configuration on
page 296) have to be enabled for a specific test to be able to change its
criteria values.

Frame Size: Indicates the frame sizes selected for the test.

TX-to-RX/P1-to-P2/P2-to-P1/Local to Remote/Remote to Local: For
each frame size, enter the minimum number of frames values at
maximum throughput allowed before declaring a Fail condition.
P1-to-P2/P2-to-P1 is only available with RTU-310.

Status: Indicates the real-time pass/fail condition.
Grey LED: Indicates that Expert Mode is disabled or the test did not
run yet.
Green LED: Indicates that the threshold is respected (Pass).
Red LED: Indicates that the threshold is not respected (Fail).

Copy From Measurement button: Copy the performance results from
the test that ran previously and use it as the Pass/Fail criteria. If no test
ran before, default values used will be 0 Frames/Burst.

Unit: Select the unit. Choices are: bps, Kbps, Mbps, Bps, KBps, MBps,
Gbps, GBps, % Util, fps (Frame Per Second), Frames/Burst, and
Bytes/Burst. The default setting is Frames/Burst.