EXFO RTU 310-310G IP Services Test Head - Manual (Page 401)

System Tabs
Ethernet Test Module 389
FC Test Preferences
FC Test Preferences
Note: Not available with RTU-310G.
Click System and Preferences/FC Test Preferences.
For RTU-310
Allows setting the default test parameters that will be applied every time a
test is created manually using Test Setup. Changes to the default test
preferences will only apply when a new test case is created. The default
test preferences can be overwritten by the test setup configuration.
The default test preferences are saved per slot on the RTU-310/310G
meaning that the configuration will not follow the module when changing
the module from one slot to another. However, a configuration on a specific
slot will remain when replacing a module by another module of the same
model.
Configuration
Laser On: Allows to select Laser On every time a test is created manually
using the wizard. This setting is selected by default.
Interface Configuration
Note: The following interface configuration parameters are available for both
ports (RTU-310).

PSP (Link Protocol): Enabling the Primitive Sequence Protocol (PSP)
allows link management. Disabling the PSP forces the port in Active
mode.

Login: Login is only available with Framed Layer 2 and allows
changing the Advertised BB_Credit value.