KEYENCE SR-750 Series - Manual (Page 32)

32 E SR-750 UM
Adding Reader with Register Button
If the SR-750 Series is on the different network, or it is placed on the network after
starting AutoID Network Navigator up, add the reader by clicking the Register
button.
1
Click the Register button .
2
If the SR-750 Series is on a different network, click the Add button
and enter the IP address of the SR-750 Series to add.
3
To have a SR-750 Series unit participate on the network after starting
AutoID Network Navigator, click the [Auto Search] button and add
the SR-750 Series unit.
To add all searched readers, check "Check all".
To add only a certain reader, uncheck "Check all" and check the reader to add.
4
Click the [Register] button.
The SR-750 Series unit will be registered in the reader view, and will be usable
by AutoID Network Navigator.
Important To add the SR-750 Series on the different network, default
gateway must have been preconfigured to the SR-750 Series.
Adding Reader with Temporary IP Address Settings
Temporary IP address is used if the IP address for the SR-750 Series is unknown
or the IP address of the SR-750 Series to register is conflicting within the network.
1
Click the Apply temporary IP address button.
2
Press the TUNE button of the SR-750 Series for 5 seconds until 4
multiple LEDs light up.
For button operation details, click here to display the button operation
description window.
3
When the address is detected, the reader information is displayed as
follows:
If the IP address shown is correct, click the OK button.
To change the IP address, click the Change button to change the IP address.
To add all readers detected, check "Check all".
To add only a certain reader, uncheck "Check all" and check the reader to add.
Important • To set a temporary IP address, the SR-750 Series must be on
the same network.
Temporary IP address cannot set for a SR-750 Series on the
different network.
• Temporary IP address setting is a function to communicate
with AutoID Network Navigator.
IP address and subnet mask etc. for the SR-750 Series must
be set according to the network to use.
• The IP address set using the Temporary IP Address Settings
is canceled when the main unit is reset. When the unit is
being connected temporarily due to maintenance, etc., turn
the power on again after the setting is complete, or perform
the main unit reset by sending the RESET command.
When a temporary IP address has been set,
the IP address is displayed in light blue.