KEYENCE IG Series User Manual
Page 131
6-2 Before Use
6-9
IG-E
6
IG Config
u
ra
tion Softw
a
re (
IG-
H1)
When [Read out the configuration data from IG.] is selected
When selecting [Read out the configuration data from IG.] to start the IG Configurator, the
configuration data is read from the IG Series and the IG Configurator starts.
When [Create a new configuration file.] is selected
When [Create a new configuration file.] is selected, [System] dialog box appears.
When selecting the system configuration of the IG Series and clicking the [OK] button, the
configurator starts with the default value for each configuration of the IG Configurator.
"Mounting the Sensor Amplifier" (page 2-2)
"3-1 Operation When the Power is Turned on for the First Time" (page 3-2)
When [Open a configuration file.] is selected
When [Open a configuration file.] is selected, [Open] dialog box appears.
When selecting the IG configuration file (*.igd, *.gvt) and clicking the [Open] button, then
the configuration file opens.
Note
• Before selecting [Read out the configuration data from IG.], check if
the PC and the IG Series are properly connected.
• Confirm that the IG is turned on.
• Confirm the DL-RS1A read/write setting switch is set to RW. If the
read/write setting switch is set to R, communication is not possible.
Reference
When clicking the [OK]
button while pressing Ctrl
+ Alt keys, the [Unit] dialog
box appears. Then you
can select either "mm" or
"inch" as a display unit.
(Initial value: "mm")