Holtgreven GSE-355 I.S. - Manual (Page 99)

90
DISPLAY READS X Enter ~ Load ~ 0.00
6. Place a 100lb test weight on scale.
DISPLAY READS X Enter ~ Load ~ 99.66
7. Enter .
DISPLAY READS X 100
8. Press 1 to establish span.
DISPLAY READS X 100.00
9. Pause for motion delay.
DISPLAY READS X Cal ~ Good? ~ 100.00
10. Press 1 to accept calibration.
DISPLAY READS X Enter ~ =Stor
11. Press 1 to save calibration.
DISPLAY READS X Enter ~ =End
12. Press 1 to exit calibration.
DISPLAY READS X 100.00
13. Remove the calibration weight.
DISPLAY READS X 0.00
First Zero Calibration Method Example (355):
1. From the Weigh Mode key in ! .
DISPLAY READS X Setup
2. Key in ( .
DISPLAY READS X Fast ~ Cal~First ~ Zero? ~ -0.26
3. Remove any load on the scale.
DISPLAY READS X First ~ Zero? ~ -0.42
4. Press ( to establish zero.
DISPLAY READS X 0.00
5. Pause for motion delay.
DISPLAY READS X Enter ~ Load ~ 0.00
6. Place a 100lb test weight on scale.
DISPLAY READS X Enter ~ Load ~ 99.66
7. Enter .
DISPLAY READS X 100
8. Press ( to establish span.