Holtgreven GSE-355 I.S. - Manual (Page 23)

14
I NTERNAL AC OR DC P OWER S UPPLY
The Model 350/355 internal power supply model may be powered by an
external VAC power source connected to (J10) on the main board. Input power
can be 85 – 265VAC, 0.5A; 50/60 Hz. See the internal AC power connector as
shown in Figure 15. The ground wire is connected to a stud on the enclosure.
The Model 350/355 internal power supply model may be powered by an
external 10-36 VDC power source connected to (J3) on the main board (also see
Battery Power Supply on page 35). The power supply should have a minimum
current rating of 800mA with no options installed, a minimum current rating of
1.25A with options installed.
Do not connect pins 3 or 4. The mating connector can be purchased from a local
electronics supplier. Recommended connectors are GSE PN: 26-20-3365 (24
AWG) or GSE PN: 26-20-3366 (22 AWG) / AMP PN: 640441-3 (24 AWG) or
AMP PN: 640440-3 (22 AWG). Connector cover GSE PN: 26-20-3389 or AMP
PN: 643075-3.
Figure 16: Model 350/355 Internal Power Supply Model DC Connections (J3)
Figure 15: Model
350/355 Internal Power
Supply Model AC
Connections (J10)
Pin 1 Pin 2 Pin 3 Pin 4 Range
DC
+ - Low
Batt
Shut
Down
12-36 VDC