Holtgreven GSE-355 I.S. User Manual
Page 119
110
Table 29: Information Parameters
PARAMETER NAME DESCRIPTION
60000
E2Ins
Total amount of EEPROM storage.
60001
E2Fre
Amount of available EEPROM storage.
60100
-GSE- ~ c1998
Copyright statement.
60101
0350P ~ 01001
Firmware revision code.
60102
02- 10 ~ 1998
Firmware date code.
60200
b sn ~ 10001
Main circuit board serial number.
60201
Audit ~ Trail
Euro ~ 00000
OIML (European) audit trail number (see OIML Audit Trail on page 104).
60202
i sn ~ 00000
Model 350/355 serial number.
60203
Audit ~ Trail
CAL. ~ 00000
Calibration audit trail number (see Calibration Audit Trail on page 104).
60204
Audit ~ Trail
Setup ~ 00000
Setup audit trail number (see Setup Audit Trail on page 104).
61100
Load ~ Cell
0.00000
Current mV/V output of the load cell.
61101
Cal ~ Factr
1.00000
Calibration factor for the load cell.
61102
Rezro ~ Load
0.00000
Amount of weight (in default units) zeroed through use of the
"
key.
61103
Zrtrc ~ Load
0.00000
Amount of weight (in default units) zeroed by the zero track feature since
"
was last pressed.
61104
CZero ~ 0P
Coarse zero calculated during calibration.
61105
Fine ~ Zero
1738
Fine zero calculated during calibration.
61106
CGain ~ 50
Coarse gain calculated during calibration.
61107
Fine ~ Gain
1.00000
Fine gain calculated during calibration.
61110
61112
Zero ~ Adj25
73741
Zero ~ Ad100
-21813
A/D compensation for coarse zero.
61117
61120
AiN1 ~ NrOff
-11035
AiN8 ~ NrOff
-14800
A/D non-ratio-metric offset compensation.
61121
Vre f~ NrOff
-12739
A/D reference voltage compensation.
61200
10oFF
Analog option 0 – 10V Zero offset value.
61201
10Gn
Analog option 0 – 10V Full scale gain value.
61202
0oFF
Analog option 0 – 20mA Zero offset value.
61203
0Gn
Analog option 0 – 20mA Full scale gain value.
61204
4oFF
Analog option 4 – 20mA Zero offset value.
61205
4Gn
Analog option 4 – 20mA Full scale gain value.
61206
Srln
Analog option board serial number.
62000
Dsply ~ Test
8.8.8.8.8.8.
Display test. Press
1
or
(
to illuminate all segments. Continue
pressing
1
or
(
to cycle through various patterns.
62001
Spt 1 ~ Disbl
62002
Spt 2 ~ Disbl
62003
Spt 3 ~ Disbl
Allows setpoint status to be changed by pressing
1
or
(
while
viewing this parameter. Requires that setup was entered using the access
code.
62004
Analg ~ 0- 10v